Baumer NE218 Manual do Utilizador descarregar pdf (Página 34)

NE218

34 www.baumer.com

No code number is set at the factor, and therefore this code request

can be skipped by pressing the key. The code is set in program-

ming line 40. After a code has been set, the programming level can

only be called by entering the correct code.

Incorrect code If an incorrect code has been input:

●

appears in the display when the key is pressed.

● After 15 seconds, the system will automatically revert to the

operating mode.

➜ Press the

key.

➜ Input the correct code.

Correct code unknown If the correct code is not known:

➜ Return the counter to the factory.

Correct code ➜ When the correct code has been input, press the

key.

● The programming segments are now called up in succession.

Programming ﬁeld 1

Here all operating parameters can be selected and changed. The

operating parameters that are blocked for the operator are also dis-

played.

➜ Press the

key again.

● The operating parameters are now called up.

The respective LED ﬂashes.

Line 1 XP - Main counter (current counter status)

Line 2

P1 - Preset value 1

Line 3

P2 - Preset value 2

Line 4

SC - Start count

Line 5

Σ - Totalizer

Line 6

- Time meter

Line 7

SF - Scaling factor

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Sem comentários

Baumer NE218 Manual do Utilizador Página 34